-
Out of stock
Complete blade 1" / 25.4mm OD 3.0mm thick walled Polycarbonate tube Internal diffusion with wrapped film diffuser and a milky polycarb' tube and tip. Reflective disc on the base of the shouldered tip is standard. This is the parabolic tip (more pointed) version. -
Heatsink module for 1" / 25mm ID tubes. Comes with centre hole and the 6x wire runs are milled to the edge of the copper heatsink. -
We've made getting quotes and paying for installations super easy! This tool is an installation quote tool for a customer provided, empty Saberforge or ASP hilt. Before using this tool, you'll need to contact us to discuss a) our installation schedule & estimated turnaround b) any special / non standard parts c) shipping options (especially if you're overseas. Li-ion batteries have a few restrictions). -
Out of stock
28mm OD x 12mm tall. 4 ohm speaker. Perfect for the Saberforge Chassis. Louder and deeper bass than the standard 2W speaker. -
Sale!
## WORKS WITH ANY SABER USING A 2.1MM RECHARGE PORT & SINGLE LI-ION CELL ## This is the charger used to recharge an illuminated saber that has a 2.1mm recharge port in its electronic setup. It has built-in safety functions including overcharging protection and an LED indicator to show when the battery is charging (red) or fully charged (green). It also features 4 interchangeable plug heads that are: Type A (US, Canada, Mexico, Japan, China) Type C (Europe, South America) Type G (UK, Malaysia, Singapore) Type I (Australia, New Zealand) The charger is designed specifically to recharge only 3.7V lithium ion batteries. Technical specifications : Input : 100 – 240VAC 50/60Hz 0.5A (max) Output : 4.2V 0.5A -
## WORKS WITH ANY SABER USING A 2.1MM RECHARGE PORT & SINGLE LI-ION CELL ## This is the charger used to recharge an illuminated saber that has a 2.1mm recharge port in its electronic setup. It's a generic charger from an OEM supplier. We've sourced and tested these and they do the job nicely. Input Voltage : AC 100-240V (Worldwide AC Input) Input Frequency : 50-60Hz Output : 4.2V 1A 5.5mm*2.1mm Over Voltage Protection Over Heat Protection -
Out of stock
Covertec belt clip -
Chassis to fit a Saberforge lightsaber hilt. This is made to hold a 18650 battery and 28mm speaker which are not included. Has a flat top surface to which to attach a range of boards. We print these to order, often tuning the length to suit your electronics cavity (leaving enough for wires but no 'rattly' gaps). Variety of colours available. Note your preference(s) in the order notes at checkout. No RCP hole, but there is a clever way to fit one on a longer chassis :) It will work with the Premium or Bass speaker -
28mm OD x 10mm tall. 8 ohm speaker. Perfect for the Saberforge Chassis. These are currently KR Sabers stock. NOT suitable for Sabertrio sabers, that require a recessed diaphragm (VECO 28mm speakers) or the recently released 22mm SaberTrio speakers + mount.
