-
This is the 'good stuff' ordered in from The Custom Saber Shop. If you need more than 0.5m, simply increase the quantity (in 0.5m lengths). -
This is the 'good stuff' ordered in from The Custom Saber Shop. If you need more than 0.5m, simply increase the quantity (in 0.5m lengths).
-
Micro Deans connectors. Same connectors used in Saberforge QC hilts. -
Single 18650 battery holder. Please note... these can be extremely tight when combined with protected 18650 cells. For example, our current protected cells are too long to comfortably fit. They are fine with unprotected cells or protected cells no longer than 69mm. -
28mm OD x 10mm tall. 8 ohm speaker. Perfect for the Saberforge Chassis. These are currently KR Sabers stock. NOT suitable for Sabertrio sabers, that require a recessed diaphragm (VECO 28mm speakers) or the recently released 22mm SaberTrio speakers + mount. -
Chassis to fit a Saberforge lightsaber hilt. This is made to hold a 18650 battery and 28mm speaker which are not included. Has a flat top surface to which to attach a range of boards. We print these to order, often tuning the length to suit your electronics cavity (leaving enough for wires but no 'rattly' gaps). Variety of colours available. Note your preference(s) in the order notes at checkout. No RCP hole, but there is a clever way to fit one on a longer chassis :) It will work with the Premium or Bass speaker -
Out of stock
Covertec belt clip -
## WORKS WITH ANY SABER USING A 2.1MM RECHARGE PORT & SINGLE LI-ION CELL ## This is the charger used to recharge an illuminated saber that has a 2.1mm recharge port in its electronic setup. It's a generic charger from an OEM supplier. We've sourced and tested these and they do the job nicely. Input Voltage : AC 100-240V (Worldwide AC Input) Input Frequency : 50-60Hz Output : 4.2V 1A 5.5mm*2.1mm Over Voltage Protection Over Heat Protection
