-
Sale!
Max Forward Voltage 3.6V Max Current 1000mA The most suitable, closest available resistor will be linked below in the 'you may also like' section. You have a little leeway in choosing the correct resistance (due to how LEDs work). it's common to 'dither' the calculated value to the nearest commercially available value. You can always double check the exact resistor values by using our LED Resistor Calculator. -
Sale!
Max Forward Voltage 3.6V Max Current 1000mA The most suitable, closest available resistor will be linked below in the 'you may also like' section. You have a little leeway in choosing the correct resistance (due to how LEDs work). it's common to 'dither' the calculated value to the nearest commercially available value. You can always double check the exact resistor values by using our LED Resistor Calculator.
-
Sale!
Max Forward Voltage 2.4V Max Current 1000mA The most suitable, closest available resistor will be linked below in the 'you may also like' section. You have a little leeway in choosing the correct resistance (due to how LEDs work). it's common to 'dither' the calculated value to the nearest commercially available value. You can always double check the exact resistor values by using our LED Resistor Calculator.
-
JST Female connector 26AWG Green 200mm long -
JST male connector 26AWG Green 200mm long -
JST Female connector 26AWG Blue White 200mm long -
JST Male connector 26AWG Blue White 200mm long -
Single 18650 battery holder. Please note... these can be extremely tight when combined with protected 18650 cells. For example, our current protected cells are too long to comfortably fit. They are fine with unprotected cells or protected cells no longer than 69mm. -
Out of stock
Covertec belt clip -
Chassis to fit a Saberforge lightsaber hilt. This is made to hold a 18650 battery and 28mm speaker which are not included. Has a flat top surface to which to attach a range of boards. We print these to order, often tuning the length to suit your electronics cavity (leaving enough for wires but no 'rattly' gaps). Variety of colours available. Note your preference(s) in the order notes at checkout. No RCP hole, but there is a clever way to fit one on a longer chassis :) It will work with the Premium or Bass speaker -
28mm OD x 10mm tall. 8 ohm speaker. Perfect for the Saberforge Chassis. These are currently KR Sabers stock. NOT suitable for Sabertrio sabers, that require a recessed diaphragm (VECO 28mm speakers) or the recently released 22mm SaberTrio speakers + mount. -
Micro Deans connectors. Same connectors used in Saberforge QC hilts.
